3D-Druck-Carrera.md

@@ -103,11 +103,11 @@ The requirements include not only technical specifications such as dimensions an
 
 Final requirements according to the adjusted specifications: 
 
-- Housing stability: The housing must be stable enough to hold all components securely (transponder, ESP32, battery).
-- Transponder position: The transponder can either be positioned at about 3/4 of the total length of the car or alternatively at the rear of the vehicle.
-- Exposed transponder: The black part of the transponder must be exposed, but must not protrude more than 5 mm from the housing. The uppermost point of the transponder must be at least at the same height as the highest point of the vehicle to ensure minimum exposure.
-- Maximum height: The maximum height of the vehicle, measured from the rail to the top edge of the transponder, may be up to 51 mm. The height of 48 mm is aimed for as a guide value, whereby a maximum tolerance range of up to 51 mm is accepted.
-- Ventilation: Sufficient ventilation for the ESP32 and the battery must be ensured to prevent overheating.
+- Housing stability: The **housing must be stable enough to hold all components securely** (transponder, ESP32, battery).
+- Transponder position: The transponder can either be positioned at about 3/4 of the total length of the car or **alternatively at the rear of the vehicle**.
+- Exposed transponder: The black part of the transponder must be exposed, but must not protrude more than 5 mm from the housing. **The uppermost point of the transponder must be at least at the same height as the highest point of the vehicle to ensure minimum exposure.**
+- Maximum height: The maximum height of the vehicle, measured from the rail to the top edge of the transponder, may be up to 51 mm. **The height of 48 mm is aimed for as a guide value, whereby a maximum tolerance range of up to 51 mm is accepted.**
+- Ventilation: **Sufficient ventilation for the ESP32 and the battery** must be ensured to prevent overheating.
 - Lamp holder: The lamp holder must be redesigned and functionally integrated into the housing.
 - Lamp cut-outs: The front lamps must be recessed and visible when lit.